Kichler 15047 Instrukcja Użytkownika

Przeglądaj online lub pobierz Instrukcja Użytkownika dla Dla domu Kichler 15047. Kichler 15047 Manuel d'utilisation Instrukcja obsługi

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj
  • Strona
    / 2
  • Spis treści
  • BOOKMARKI
  • Oceniono. / 5. Na podstawie oceny klientów
Przeglądanie stron 0
FOR USE WITH LANDSCAPE LIGHTING SYSTEMS ONLY.
1) The device is accepted as a component of a landscape lighting system
where the suitability of the CSA or UL labeled combination shall be deter
mined by CSA, UL respectively or the local inspection authorities having
jurisdiction.
2) Fixture shall be connected to an extra low voltage transformer approved
for use with landscape lighting systems.
3) Thisxtureistobeconnectedtoasecondarywiringofthefollowingtype:
12 GA 60°C minimum type;
SPT-3 suitable for outdoor use; or
approved landscape lighting cable.
ASSEMBLY AND INSTALLATION
1) Determinedesiredlocationformountingxture.
2) Usingg.A,markpositionfordrililngpilotholesandforwirewayhole(if
desired).
NOTE: Fig. A is drawn actual size, it can be used as a template or referenced
for dimensions.
3) Drill3/32”(2mm)pilotholesinmountingsurfaceatpositionsmarked.If
usingawirewayholealsodrillthatatthistime.Suggestedsize1/4”(6mm).
4) Assemblemountingbrackettomountingsurfaceusingprovidedscrews.
5) Insertbulb.
6) Carefullyslipxtureovermountingbracket.
7) TURN OFF POWER. Disconnect or unplug transformer.
8) MakewireconnectionsusingsuppliedQuicDisc
following instructions
below,orusingotherapprovedwiringconnectionmethod(notsupplied.)
Date Issued: 11/25/11 IS-15047-CB
OUTDOOR USE ONLY
DOM ETRE INSTALLE A L’EXTERIEUR
INSTRUCTIONS
For Assembling and Installing Fixtures in Canada
Pour L’assemblage et L’installation Au Canada
For warranty information please visit: http://www.landscapelighting.com/portal/warranty_page
Pour de plus amples informations sur la garantie, cliquez sur le lien ci-dessous : http://www.landscapelighting.com/portal/warranty_page
QUIC DISC
WIRING INSTRUCTIONS
Turn off power.
Thefulllengthofthe18GAxturewiremaybeusedtoconnectwiththe10GAor12GAcableprovidedthefollowingconditionsaremet:
•Wiringistobeprotectedbyroutingclosetothextureoraccessoryorsecuredtoabuildingstructuresuchashouseordeck.
• 18GAxturewiringistobecutoffsothatitisattachedtotheconnectorwithin6inchesofthextureorbuildingstructure.
• Ifitisnecessarytomaketheconnectionsunderground,thennomorethan6inchesofthe18GAxturewireistobeburied.
TheQuicDisc
connector is designed to install onextureandaccommodatesone18GAxturewireandone 10 GA or one 12 GA supply wire.
Placethe10gaugesupplywireacrosstheareamarked10GAonQuicDisc
orplacethe12gaugesupplywireacrosstheareamarked12GA
onQuicDisc
.
Placethe18gaugexturewireacrosstheareamarked18GAontheQuicDisc
.Afterthewiresareinplace,connectathetopoftheQuic
Disc
tothebasewithsuppliedscrew,makingsurethatthewiresremainatinthebottomportionoftheQuicDisc
, and the screw is tightened
all the way down.
Thecoppercontactswillautomaticallypiercethewires’insulation.Excess18GAxturewirethatsticksouttheendoftheQuicDisc
is to be cut off.
Makenootherwiringconnectionstothe18GAxturewire.
1/4”
WIREWAY
HOLE
6MM
TROU POUR
LEGUIDE-
FIL
3/32”
MOUNTING
HOLES
2MM
TROUS
PILOTES
5/16”
5/32”
3-1/2”
WIREWAYHOLE
TROUPOURLEGUIDE-FIL
MOUNTINGBRACKET
SUPPORTDEFIXATION
SCREW
VIS
BULB
AMPOULE
Przeglądanie stron 0
1 2

Podsumowanie treści

Strona 1 - INSTRUCTIONS

FOR USE WITH LANDSCAPE LIGHTING SYSTEMS ONLY.1) The device is accepted as a component of a landscape lighting system where the suitability of the C

Strona 2

A UTILISER UNIQUEMENT POUR LES SYSTÈMES D’ÉCLAIRAG PAYSAGER1) Le dispositif est accepté en tant que composant d’un système d’é clairage paysager lor

Powiązane modele: 18003

Komentarze do niniejszej Instrukcji

Brak uwag